Cutting Crown Molding For Top Of Cabinets

Crown molding that sits atop kitchen cabinets gives them a solid finished look.

Cutting crown molding for top of cabinets.

Place your tape measure on the edge of the crown. Measure and mark the molding with the length of the front piece of baseboard starting from the deepest part of the 45 degree cut. Set the miter saw to a 45 degree angle cut. Learn how to angle cut the gussets and where to locate them on the top of the cabinet.

For strength and stability gussets are added to the top. Take a piece of molding. Cut strips of the 5 4 pine to length and width based on the size of the cabinets. You don t want this molding to pull off the cabinet if someone pulls or pushes on it when moving the cabinet for example.

How to easily cut crown molding. These will be the filler pieces. Measure and cut all pieces of crown before nailing any to the cabinet. Once the cuts are all made.

Cut a 45 degree angle off the opposite side so the deepest part of the cut meets the mark just made. Cutting straight pieces 1. Starting at an outside corner of the cabinets measure the span going to the right. I find that holding the piece of crown moulding up to the cabinet and marking where it needs to be cut is far more effective than trying to measure the cabinet with a measuring tape and transferring that measurement to the crown moulding.

Measure and cut the crown molding front section measure and mark the front section of crown molding to the cabinet width. If the edge of your piece will sit flush against a wall or frame a straight 90 cut. Turn the miter of the saw to 45 degrees right so it s facing away from the trim. Take a piece of crown molding longer than the front of the cabinet and cut a 45 degree angle off one side.

Hold the bottom of the. Place the crown molding so that it is rests upside down and at a 45 degree angle against the saw fence. Steps for hanging crown molding. Set your saw to a desired angle.

Measure a piece of crown molding equal to the length of the cabinet. Make rabbet cuts on the filler pieces so that the piece fits tightly on the top of the cabinet and over the door of the. Cut strips of 3 4 inch x 1 1 2 inch wood to the length of the top of the full run of cabinets as well as another piece cut to size for each exposed side cabinet view that requires crown molding.