Cutting Cultured Marble With Angle Grinder

Place the marble on a sturdy workbench or table with an area large enough to hold the marble so that it does not.

Cutting cultured marble with angle grinder.

Using a hand clamp to hold the hose in place direct a trickle of water on the front of the diamond blade to cool it. Diy how to cut quartz granite or marble countertops with a circular saw. Attach a diamond cutting blade to an angle grinder. Beyond simply choosing the tools themselves there are a variety of ways to cut cultured marble depending on where it will be installed.

It turns out cutting the cultured marble is fairly easy but slow. With light pressure begin drilling through the duct tape and into the cultured marble on the pencil mark. Make accurate marks. It cuts by grinding more than what we think of cutting.

Adjust the angle grinder s speed to 2 800 r p m. No special tools are needed. Press a 50 grit diamond grinding disk against the angle grinder s round pad. A diamond blade like used for tilework is basically microscopic diamond dust.

A carbide wood blade stays sharper longer and would make a clean cut on cultured marble. With such a wide variety of products available knowing which tools to choose when it comes to cutting cultured marble can be somewhat confusing. Protect your marble slab by placing it on a 2 in. Secure the cultured marble with clamps and vice grips to keep it from slipping while you drill.

Thick piece of rigid foam. In this video house renovation brothers dave and rich show you how to cut a marble countertop. It would quickly clog up with a thermoplastic material. How to cut marble with a grinder step 1.

You must be patient and apply a firm and constant pressure to the saw grip handle. Most home improvement centers sell a wide variety of. Put on your eye protection and make your cut. It shows how to cut using both dry and wet techniques.

I have read where folks have used jigsaws or routers to cut out a sink from cultured marble. However if you push too hard it slows the saw motor or worse it can break the blade. A new good quality wood blade would do it too but might get. All you need is a circular saw with a diamond tipped blade.