Cutting Led Strip Lights

Led strip lights are designed to be easy to cut apart with a pair of scissors.

Cutting led strip lights.

An led strip light is typically half an inch 10 12 mm in width and up to 16 feet 5 meters or more in length. From there you can connect the leds to a power source either through a quick connector or by soldering. There are cut marks in the led strip light pcb normally dc12v led strip light is 3leds unit dc24v led strip light is 6leds unit you can see copper dots in the cut marks don t cut anywhere else the cut marks otherwise one unit of the led strip light won t work. Cutting the strip in the wrong area will lead to some of your led lights not working.

Step 4 use the wire to strip light connector. Individual leds are mounted along the strip typically at densities of 18 36 leds per foot 60 120 per meter. I took a small paring knife and made a cut just inboard of the copper pads close to the and symbols. Govee led strip lights 16 4ft rgb led strip with remote and control box bright 5050 leds colorful light strip easy installation cutting design led light strip for room bedroom living room kitchen 4 6 out of 5 stars 8 248.

Look for the cut line the cut line usually comes in the form of two copper dots. Purchase led lights and all the connections. Measuring the led strips light will help you cut the right length and install the perfect led strip lights perfectly. Your led light strip will have markings along the strip telling you where you re allowed to cut often marked by orange or brown dots or even a small picture of scissors.

Use a knife to remove the coating above the copper pads. Each led has a pair of copper dots at the end. When soldering led strip lights the first step is to remove the clear coating on top of the copper pads. Govee led strip lights 16 4ft rgb led strip with remote and control box bright 5050 leds colorful light strip easy installation cutting design led light strip for room bedroom living room kitchen 4 6 out of 5 stars 7 878.

They can be cut to specific lengths using just a pair of scissors along the cutlines located every 1 2 inches. If you see two copper dots then you ve found the place where you should cut the strip.