Cutting Long Straight Boards For Flooring

This is one of the tools every professional uses to cut laminate floor boards to length and is the key to how to cut a laminate floor.

Cutting long straight boards for flooring.

This article is about how to cut wood straight cutting straight lines in wood is essential for any woodworking project therefore you have to master these techniques. Clamp the plank to your work surface so the cutting line is overhanging beyond the edge of the surface. This method results in a board of consistent width and parallel sides whether the board you re. In this diy how to cut wood flooring video we ll show you over a dozen difficult cuts and how to cut wood flooring around doors cutting wood floors and ho.

For this method you must nail the board directly to the sawhorses with finish nails photo 1. You can make a straight rip with a fence as long as it doesn t result in a gap on one end of. Use 4d finish nails for 3 4 in. In order to get accurate cuts clamp the straight edge or a laminate flooring plank to your board making sure the blade of the jigsaw goes exactly over the cut line at both sides.

Rather than sawing the laminate the cutter chops it using a tough blade and a long handle used to exert downward force. Keep your board in place using a stand or a clamp. Thick wood and 8d finish nails for 1 1 2 in. Cut badly bowed boards into shorter lengths.

Mark and measure where you want to cut the boards beforehand with chalk or pencil. When ripping the boards to fit the tongue side of each board will be the off cut. Wear goggles a mask and gloves. This process can take up to 2 hours depending on how many boards you need to cut.

Place the laminate flooring board on a sturdy surface saw horse and lock it into position with several c clamps or with the help of a friend. Make a wedge to drive slightly bowed boards together. If the gap won t tighten up cut the board into shorter lengths. Cut the wedge from a scrap of flooring with the groove left on.

To make an angled rip cut for the first or last row of flooring mark the cutting line on the backside of the plank using a straightedge or chalk line to ensure a straight line. From our experience we can assert that cutting straight lines in wood is easier if you use power tools such as a jigsaw or a circular saw as compared to a hand saw. Drive the wedge between the flooring board and a scrap board screwed to the subfloor. After removing two sections of partition wall i needed to patch the hardwood i decided to run two courses of tongue and groove perpendicular to the exis.