Cutting Paving Stones By Hand

Tips for cutting pavers.

Cutting paving stones by hand.

A curved shaped patio may need more cuts which may need a power saw to do the cutting. When installing a patio or walkway with paver stones there will almost always be areas where the pavers must be cut to fit in irregular areas or around objects. Power saw and concrete blade. Once you know your measurements use a straight edge to mark cutlines onto all 4 sides of your paver.

A chisel and heavy hammer in the hands of an experienced professional easily cut natural stone clay and concrete pavers. Score the curved cut along the top of the paver first cutting about 1 8 inch deep. Cutting pavers with a power saw. All standard cutting methods work for straight cuts but for curved cuts use a circular saw or angle grinder.

If the area to install the brick pavers is a square shaped patio few cuts are needed which could be done by hand. Then gently tap your 1 inch wide cold chisel with a hammer until you have a 1 16 inch groove along the entire cutline. Strike the chisel on the score line until the material splits. Use the hammer and chisel to score or cut a groove into the block or paver on all sides.

Set up workhorses or preferably a work stand with adjustable sides to secure the pavers. Cutting paving stones can be daunting but it isn t difficult. Cut paver stones with a chisel for areas that require smaller paver pieces. Mark the cut and clamp the stone or paver to a stable work surface.

Depending on the thickness of the concrete you may have to raise the blade and cut through only a portion of the paver. In this diy tutorial we re going to show you six different ways to cut a paving stone in order from basic to advanced. Another method for cutting concrete pavers is to use a hand held power saw such as a skillsaw with a masonry blade or a cut off saw. For an amateur using a chisel and hammer is the best and.

Make a full straight cut that is tangential to touching the scored line and break off the bulk of the waste. For a larger project or more accurate cuts a circular saw with a concrete blade is a good option. We ll start with a classic hammer and chisel and end with a high tech masonry saw while covering a handful of other great options in between. While holding the paver in place with one hand tap the overhanging end firmly with a hammer or a mallet.