Cutting Rgb Led Strip Lights

An led strip light is typically half an inch 10 12 mm in width and up to 16 feet 5 meters or more in length.

Cutting rgb led strip lights.

Led strip lights can be cut at 5 or 10 cm intervals depending on the type of strip light purchased. Rolls of 5 meters length are supplied and very often needs trimmi. If you cut outside of the cut lines that section of led strip will fail to work. Cutting through or before the copper dots will result in no electrical conductivity to the following section.

To seperate your strip lights cut along the line using a pair of scissors or craft knife. Individual leds are mounted along the strip typically at densities of 18 36 leds per foot 60 120 per meter. Do not cut until reading steps 2 and 3. 2 cut the led strip light.

The cutting points are clearly marked with a straight line. You should be cutting between the copper dots. Great little video that shows step by step process of cutting and joining led strip lights. Line up the cut carefully to avoid damaging the leds.

When cutting led strip light it is very important to cut only on the given cut line between the copper dots. They can be cut to specific lengths using just a pair of scissors along the cutlines located every 1 2 inches. A pair of scissors will do the job. On the bottom of the rgb neon strip there are black marks that represent the products cut lines.

Locate the cut line. Hold the lights still and cut along the dotted line. Govee led strip lights 16 4ft rgb led strip with remote and control box bright 5050 leds colorful light strip easy installation cutting design led light strip for room bedroom living room kitchen 4 6 out of 5 stars 8 144. Step 3 cut the led strip light with scissors.

There are cut marks in the led strip light pcb normally dc12v led strip light is 3leds unit dc24v led strip light is 6leds unit you can see copper dots in the cut marks don t cut anywhere else the cut marks otherwise one unit of the led strip light won t work.