Get tips on using safety glasses and an old carbide saw blade which will cut right through the staples in the door.
Cutting solid core door.
Cutting down a door that does not fit its opening.
Custom sizes door prices are ridiculous and the wood core doors that are designed to be cut don t last very long on the coast.
I ve got a couple to replace that are only about an inch short of standard height.
The blade will pass through the.
If you cut material away from the doorknob side it will change the backset the distance from the doorknob to the edge.
Stretch a piece of masking tape centered on the marks across the door from side to side.
First mark the clearance needed on the door.
Tape tarp to cover all lower cabinets and floors tape bottom of countertop edge create a dam with tape along the countertop edge next to any appliances like your range if they are not easily removed pour entire epoxy activator into epoxy resin can and mix for exactly 3 min 15 sec only mix one.
Measure and make a mark on both sides where you wish to cut the door.
The rails at the top and the bottom of the door are only 1 inch thick.
Anyone ever try cutting an anderson storm door the solid aluminum doors not the wood core emco doors.
Exterior doors are usually solid core and are much heavier than the interior hollow core doors.
If one is cutting down a solid core door clean out the core material as david described then use the cutoff piece to reblock the door.
Cutting interior doors is not the same as cutting exterior doors.
Wide strip of masking tape along the line to protect the door s finish from the circular saw s base plate.
You will need to clean off the skins but the piece should fit back in well.
Find out how to cut off a solid core door.
There is only about 1 inch to play with so you must be careful when cutting the length of the door.
When cutting the width of the door cut it on the hinge side.