Cyclone How To Adjust Tension On Electric Awning

Eventually you should get it to rotate all the way around.

Cyclone how to adjust tension on electric awning.

How to adjust awning arms www awningdepot co uk. Position so the pole pushes the awning out adding tension to the fabric. 1 lower the awning so the roller tube is as close to the ground as possible. Push the aluminum pole in its extended length up to the rv wall and down to the lip of the awning under the awning itself.

Remove the 2 phillips head screws from the bottom end of the outer section. 2 the support arm consists of an outer and inner section. See our channel page for link the home on the road series consists of three 2 dvd. Standing at the front of the awning and facing the rear you need to rotate the front awning leg counter clockwise.

Some electric systems have a spring on the rear side of the awning if it is really long but this will make it harder to go out not in. Others might require you to use a hand crank extended device. Since this is the side with the ratchet catch the awning might try to roll up on you some just tell your helper to hold it tighter. Adjust awning tension adjust spring tension rv awning how to adjust the tension on an rv awning awning tighting adjustments how to adjust spring tension on rv awning rv awning tension loose adjust rv awning spring rv awning spring tension.

Place the step stool near the lip of the awning. The tension arms are what you adjust to make the awning taut after it has been lowered. In this event just place the crank into the socket and begin to spin it until the awning is the right size. Some have electronic motors that will allow you to adjust the awning automatically with the push of a button.