Damp Proof Course Above Internal Floor Level

Selection of materials for damp proof course in buildings.

Damp proof course above internal floor level.

As it dries out the damp retreats slowly back to the points of ingress so if you are not able to see any isolated damp areas either ventilate and heat or shut all the doors and windows and use a dehumidifier. Types of materials for damp proof course. A quick summary checklist. Dpc material for cavity walls.

Waterproof is defined by the astm as a treatment that resists the passage of water under pressure. Tip 1 if a concrete floor is damp all over it is hard to isolate the moisture source. Houses are usually built with a damp proof course dpc just above floor level to prevent moisture rising up but if this has failed or the property did not have a dpc then rising damp can occur. External ground levels ideally need to be lowered 150mm below the damp proof course or the internal flooring.

By simply lowering external ground levels this will allow wall base evaporation to help control rising dampness. Rising damp usually occurs in masonry walls because of the failure or absence of a damp proof course although poor sub floor ventilation and bad site drainage can also be contributors. Generally damp proofing keeps moisture out of a building where vapor barriers keep interior moisture from getting into walls. Dpc material for floors roofs etc.

Dpc material for situations where differential thermal movements occur. Damp proofing is defined by the american society for testing and materials astm as a material that resists the passage of water with no hydrostatic pressure. The below diagram shows what bridging of the damp proof course looks like. Damp below damp proof course level.

Depending on the extent of the rising damp this can be a more costly and extensive job to repair.